How to maintain the motor of the industrial door?

How to maintain the motor of the industrial door?

It is forbidden to hammer. If it is loose, it needs to be determined and fixed by tapping. It is necessary to control the force road to avoid problems with the internal parts of the hammer being hammered.

Regularly change the motor lubricating oil. After the motor is used for a long time, the lubricating oil in the fuel tank will inevitably have pollutants. If it is not regularly checked and replaced, it may cause frequent vibration and noise during the operation of the industrial sliding door, and even Can not run.

The position where the motor is installed should be kept dry and ventilated as much as possible. Do not be in a dark and humid place, so as to prevent the electronic components inside the motor from being corroded by the moisture in the air, causing electric leakage accidents, endangering personal and property safety, and regularly carrying out dust on the motor surface. Clean up to prevent dust from entering the inside of the motor and causing malfunctions.

The motor of the industrial door should not be placed in the position of strong light exposure, because the outer casing of most industrial door motors is made of stainless steel, etc., and the anti-aging performance is not strong and easy to damage.

Regularly check that the motor parts of the sliding door are in good condition. If there is damage, you need to power off and replace it.