Some useful solutions to solve the malfunction problem of medical airtight doors

Some useful solutions to solve the malfunction problem of medical airtight doors

Case 1: The medical sliding door is too noisy during the running process.

(1) The noise generated by the friction of the movable door leaf during operation and on the fixed door or the wall can be adjusted appropriately outside the door;

(2) The spreader wheel of the airtight door is worn out because it is used for a long time, and only needs to be removed, cleaned and lubricated;

(3) Some fixed parts are loose and only need to be reinforced;

(4) The box and the guide rail are not installed at the time of installation, and the gypsum board of the ceiling ceiling produces a resonance effect;

(5) If the door clamp or the track of the fixed door panel is damaged, it is necessary to remove the box to see if there is any damage inside, and if necessary, it needs to be replaced;

Case 2: Automatic switching when the medical sliding door is unmanned

(1) If there is a radar, it may be that the object that is often moved by the radar sensor passes or is irradiated to the door itself, and only needs to adjust the irradiation range or sensitivity of the radar;

(2) Another situation may be that the safety photoelectric is blocked by the object, and it is necessary to check the safety photo electricity;

Case 3: The door is running too slowly

(1) It is possible to manually adjust the speed inside the controller. If the adjustment is slow or slow, the power of the motor may be low and cannot be pulled. At this time, it is necessary to consider changing the motor with a larger driving force;

(2) Loose or loose spreaders may also cause this problem;

If the damage is serious, you should contact the manufacturer of the installation as soon as possible to avoid accidents.